Worked examples to EC3 quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Worked examples to EC3

How is ε calculated?

No need - its given in the tables
ε = (235/fy)1/2
ε = (275/fy)1/2
ε = (355/fy)1/2

Which bending modulus should be used with a Class 2 section?

Elastic modulus
Plastic Modulus
Effective Modulus
Young's Modulus

Having calculated the non-dimensional slenderness, how might the reduction factor, χ, be determined?

Using the expressions given in EN 1993
Using the figure given in EN 1993
Using look-up tables in NCCI
Using look-up tables in EN 1993

When calculating the cross-sectional resistance of a member, what is the value of the partial factor, γM0 specified in the UK National Annex?

1.0
1.05
1.1
1.15

In flexural buckling, what non-dimensional slenderness is approximately equivalent to a slenderness L/ryy = 160?

1.0
2.0
3.0
4.0

What structural mechanics is allowed for in the C1 factor when calculating Mcr?

The influence of the axial load
The influence of residual stresses
The shape of the bending moment diagram
Initial imperfections in the member

Which class of sections use the Gross Area, A when calculating the resistance?

Class 1
Class 2
Class 3
Class 4

Where does a designer find values of C1 for different shapes of bending moment diagram?

In BS EN 1993-1-1
In the UK National Annex to BS EN 1993-1-1
In NCCI
In an appendix to BS EN 1993-1-1

Which approach to lateral-torsional buckling of UKB is recommended for manual calculations in the UK?

The general method
The simplified assessment method
Buckling curves - the general case
Buckling curves - for rolled sections and equivalent welded sections

What value of ξ is specified in the UK National Annex?

The recommended value of 0.85
0.925
0.950
0.875