Introduction to EC3 quiz

Please answer the following 10 multiple choice questions, then click 'submit' to check the result. The pass mark for a CPD certificate is 8 out of 10, and you may retake the quiz as many times as you wish, but the questions will vary! Please note that one, two, three or all of the possible answers presented for each question may be right, and to gain a mark for that question all correct answers must be identified.

Good luck

Introduction to EC3

Which of the following statements about columns in 'simple construction' are correct?

Only open sections (UKC) can be used
Design moments in the columns are based on nominal eccentricities
Beams are designed as simply supported
The approach cannot be used in Eurocode design

Which forms of buckling might apply to a UKC, subject to an axial compression and a bending moment?

Flexural
Torsional
Torsional-flexural
Lateral-torsional

When would a designer need to refer to BS EN 1993-1-5 and its UK National Annex?

When determining snow loads
When calculating the resistance of the webs of rolled sections
When selecting a steel sub-grade
For design guidance on stainless steel

If a web is Class 3 and a flange is Class 1, what Class is the section?

There must be some mistake; both elements should be the same Class
Class 1
Class 2
Class 3

When can the Eurocodes be used?

When Approved Document A in the Building Regulations is revised
Only when the client specifies design to the Eurocodes
Immediately
Only for projects outside the UK

What structural mechanics is allowed for in the C1 factor when calculating Mcr?

The influence of the axial load
The influence of residual stresses
The shape of the bending moment diagram
Initial imperfections in the member

What best describes a 'destabilising' load?

One applied between restraints
A load applied to the top flange
A load which is free to move laterally with the buckling flange
A non-vertical load, with a lateral component

Which of the following increase the risk of brittle fracture?

Colder temperatures
Tension
Thicker steelwork
Higher strain rates

In flexural buckling, what non-dimensional slenderness is approximately equivalent to a slenderness L/ryy = 200?

0.5
1.5
2.5
3.5

In expressions 6.61 and 6.62, what structural mechanics do the k factors account for?

The residual stresses in the member
The shape of the bending moment diagram
The influence of the axial load
The section shape